Blog-New

Big Sky Nordic Skiing Waxing Tips

Main Image

The town of Big Sky, and Big Sky country in general, is a mecca for Nordic skiing. Between Lone Mountain Ranch and the miles of groomed ski trails around the greater Gallatin County region, nordic skiing, and specifically skate skiing, is one of the best activities for getting into the woods and away from the crowds, fast. But unlike downhill skis, skate skis require more frequent waxing and at-home care, especially now as the weather changes from winter to spring-like conditions. This may sounds overwhelming, but don’t worry; waxing is one of the sublime pleasures of being a nordic skier. Here’s a quick primer on the basics of waxing skate skis:

What you’ll need:

1) Ski vice or clamps, homemade or store bought
2) Glide wax
3) Scraper
4) Waxing iron
5) Cork block

The Process:

Before being stowed away every spring, skate skis should receive a coat of “storage wax”, which needs to be removed every fall. After affixing your skis to your chose work surface, set your wax iron to medium heat and begin slowly heating the base of your ski. As the iron and the ski get hotter, the existing wax with turn ghostly white and stand out. Scrap off all the old wax to give yourself a new start.

After the ski is stripped and ready for wax, it’s time to give your skis their first coat of glide wax for the winter. Begin the waxing process by holding your wax block at a steep downward angle to the face of the iron, allowing hot wax to drip onto the ski.

Cover the ski with little blotches of wax from tip to tail. After the ski is fairly covered, begin spreading the wax around the ski’s base by running your iron in circular motions across the ski’s base. You will see the wax melt and spread. Continue this waxing motion until the ghostly white wax covers the ski base entirely. Because nordic skis have relatively soft bases, be careful to not melt the ski’s base.

Now it’s time to scrape. Hold your wax scraper at 45-degree angle to the ski as you pull the scraper towards yourself. You’ll see satisfying curls of excess wax pull from the ski. Once the excess is pulled from the ski, the bases should appear shiny and smooth. If you want to put some additional elbow grease into the work, buff the skis bases with a cork block to work the wax into the base.

Now get your skiing clothes on and get out the door!